Home > Boards > Modules > Power
Power Supply Modules

DC-DC Step-Up Module With Display
Compact, Easy to Use Step-Up DC-DC Voltage Module with Display. Ideal for stepping up voltages for motors or running 12V Lighting. Precision Digital Display shows the output voltage and a sealed high-accuracy trimpot is used to set the output voltage.
Part Code: DCDCSTEPUPDISP
Features
- Easy to Connect, PCB Terminals
- Suitable for up to 3A
- Accurate Output Voltage Display
- Input: 3.5V - 32V DC
- Output: 5V - 35V DC
- Dimensions: 68mm Length, 42mm Width, 12mm Height

DC-DC Step-Down Module With Display
Compact, Easy to Use Step-Down DC-DC Voltage Module with Display. Ideal for stepping down voltages from 12V batteries or systems to power your control board and Arduino® Uno. Precision Digital Display shows the output voltage and a sealed high-accuracy trimpot is used to set the output voltage.
Part Code: DCDCSTEPDWDISP
Features
- Easy to Connect, PCB Terminals
- Suitable for up to 2A
- Accurate Output Voltage Display
- Input: 4.5V - 35V DC
- Output: 4V - 34V DC
- Dimensions: 66mm Length, 36mm Width, 12mm Height

DC-DC Step-Up Module
Compact, Easy to Use Step-Up DC-DC Voltage Module. Ideal for stepping up voltages for motors or running 12V Lighting. A sealed high-accuracy trimpot is used to set the output voltage.
Part Code: DCDCSTEPUP
Features
- Solder Terminals for Connection
- Suitable for up to 4A
- High-Efficiency Conversion with Low Ripple
- Input: 3V - 32V DC
- Output: 5V - 35V DC
- Dimensions: 43mm Length, 21mm Width, 12mm Height

DC-DC Step-Down Module
Compact, Easy to Use Step-Down DC-DC Voltage Module. Ideal for stepping down voltages from 12V power supplies to run an Arduino® board or PIC® Microcontroller Board. A sealed high-accuracy trimpot is used to set the output voltage.
Part Code: DCDCSTEPDW
Features
- Solder Terminals for Connection
- Suitable for up to 3A
- High-Efficiency Conversion with Low Ripple
- Input: 4V - 35V DC
- Output: 1.5V - 30V DC
- Dimensions: 43mm Length, 21mm Width, 12mm Height

30A Current Sensor Module
The module outputs a voltage proportional to the amount of current passing through the PCB terminals. Output voltage ratio is 66mV/A.
Part Code: CURRMODULE
Features
- 3 Pin Header (2 Power Supply, 1 Measured Current Output Pin)
- Suitable for up to 30A
- Measures both positive and negative current flows
- Isolation between measured current and logic circuit
- Power ON LED
- Dimensions: 31mm Length, 13mm Width, 12mm Height